INSTALLING THE UNIT
Step 6
:
Install both chimneys and tighten screws to secure the lower
chimney to the range hood as shown in Figure 5
.
Step 7
:
To avoid scratching the chimney, extend the upper chimney
slowly and carefully to the chimney-mounting bracket and
tighten screws as shown in Figure 6
.
NOTE
: Remove the protective plastic film covering the top chimney
cover and the hood.
Step 8
: Insert the oil tunnel (see figure 7).
Step 9
:
To install the filters, refer to Figure 8 by following the steps
below:
1.
Point the filter toward the rear of the hood.
2.
Push the filter until it is level.
3.
Slide forward in the check mark on the front of the hood.
4.
Lower the filters.
5.
Slide back until it snaps into place.
Step 10
:
Turn power ON in control panel. Check all lights and fan functions.
23
Fig. 5
Fig. 6
Fig. 8
Fig. 7
