4
before using it.
15. AVOID UNINTENTIONAL STARTING. Don’t carry tools with a finger on
the switch. Be sure the direction switch is in the STOP position when not in
use or when changing attachments.
16. STAY ALERT. Watch what you are doing & use common sense. Don’t
operate any tool when you are tired.
17. CHECK FOR DAMAGED PARTS.
1) Before using the tool, any part that is damaged should be carefully
checked to determine that it will operate properly and perform its intended
function.
2) Check for alignment of moving parts, binding of moving parts, breakage
of parts, mountings, and other conditions that may affect its operation.
3) Check bits and blades to make sure they are sharp and not chipped.
Inspect screws and tighten any ones that are loose.
4) Any part that is damaged should be properly repaired or replaced by an
authorized service center unless otherwise indicated elsewhere in the
instruction manual. Have defective switches replaced by an authorized
service center? Don’t use the tool if the switch does not turn on and off
properly.
18. GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with
grounded surfaces such as pipes, radiators ranges, and refrigerator
Summary of Contents for ACD306-N
Page 20: ...19 SCHEMATIC DRAWING ...
Page 21: ...20 ...
