Avid Power ACIW124, Operator'S Manual

6

„

Impact wrenches are not torque wrenches and are not designed or capable of 
installing fasteners to specified torque. For fasteners requiring a specific torque, install 
the fastener to well below the required value then complete the task with a hand 
torque wrench to avoid damaging the fastener or workpiece.

„

Ensure the anvil ring is correctly maintained and if damaged or missing, replace it 
immediately before work commences. Missing or damaged anvil rings may lead to 
sockets detaching from the wrench while rotating at high speed.

„

Only use accessories specifically hardened for impact use. Do not use standard 
chrome type hand tool sockets as they will shatter and splinter.

„

Do not modify this impact wrench in any way.

„

When starting or finishing the removal and installation of fasteners there is a risk of 
cursing between the tool and the workpiece due to sudden movement or reaction 
forces.

Residual risk
Important: 

Although the safety instructions and operating manual for our tools contain 

extensive instructions of safe working with power tools, every power tool involves a 
certain residual risk which can not be completely excluded by safety mechanisms. 
Power tools must therefore always be operated with caution.

Safety Instructions for Mains Powered Battery Packs and Chargers
Chargers

„

The charger is for indoor use only.

„

Before plugging the charger into the supply, check that the plug and the cable are in 
good condition. If either is damaged, have the defective item replaced immediately by 
a qualified person.

„

Only use a correctly rated mains outlet to provide power, do not plug into site 
generators, attach to engine generators or D.C. sources. Do not use a mains socket 
outlet that is not switched.

„

Use the correct charger in conjunction with its corresponding battery pack.

„

Do not charge any other batteries with the chargers. Any other application is 
considered misuse.

„

Do not attempt to charge battery packs that are too hot (over 30°C) or too cold (under 
5°C), if these conditions apply, set the battery pack aside to "normalize" before 

SAFETY INSTRUCTIONS