AirSpeed Multi Stream Configuration
97
Configuring the Avid Service Configuration for Interplay Workgroup
This topic describes how to configure the Avid Service Configuration for Interplay
Workgroup, including creating Record and Destination templates.
Before you configure the Avid Service Configuration, you must create a user with an
AirSpeed Multi Stream user name with matching passwords (recommended Avid1234) in
both Interplay and Unity. For more information, see the
Avid Interplay Access
Administration Guide
.
There are five stages to configure the Avid Service Configuration for Interplay Workgroup.
They are listed in the checklist below and each is described in detail following the checklist:
Configuring the Avid Service Configuration
The first step is to configure the Avid Service Configuration.
To configure the Avid Service Configuration:
1. On the AirSpeed Multi Stream, select Start > Programs > Avid > Avid Framework >
Avid Service Configuration.
The Select Workgroup dialog box opens.
2. Do the following:
a.
Type the name of the workgroup you want to use.
b.
Select the “Always select and use this Workgroup” check box.
c.
Click Select.
The Avid Service Configuration dialog box opens, and a list of all of the servers
connected to the Avid Service Framework appears. In the Hosts column, your AirSpeed
Multi Stream system name appears in the list in bold type (if you are connected to that
system).
Configure the Avid Service Configuration. See
Set up your credentials for Interplay and ISIS or Unity. See
for Connection to Interplay” on page 98
.
Set up Record and Destination templates. See
“Setting Up Record and Destination
.
Select Default templates. See
“Selecting Default Templates” on page 102
Set up Inventory rules. See
“Setting Up Inventory Rules” on page 104
.
Summary of Contents for AirSpeed series
