RM1/RM2 Drive Unit Replacement
Þ
Before printing, consider the environment
1
Tools required:
- 3mm hex driver
(for Tweeter replacement)
-
5mm hex driver
(for Woofer replacement)
Replacement parts:
- RM1 130mm LF driver or
-
RM2 170mm LF driver or
-
RM1/RM2 HF driver
Please note
that if you claim any of the replacement parts as
warranty replacements, you will need to return the part(s) as soon
as possible, properly packed to avoid shipping damage (which
will automatically void warranty). Warranty status will be
confirmed after analysis at PMC Ltd within approximately 6
weeks.
Replacing the LF (pictures left) or HF (pictures right) driver
-
Place the unit on a smooth surface (use a towel or foam underlay to avoid scratches).
Tilt the unit by 90 degrees, so it rests on its back panel
-
Remove the hex screws that hold the driver in place:
-
Remove the aluminum ring off the LF drive unit:
-
CAREFULLY
tilt the speaker back in its upright position. Hold the driver unit back in
place with one hand (it will fall out otherwise!) Once the speaker is standing upright,
remove the drive unit.
