Replay |
90
3. W
o
rking with Con
tr
o
ller
Clips
The clip saving functionality remains unchanged for all server channels. If outputs are
tied, the channel loaded to the “Red” output becomes the master angle.
When channels are untied, the output performs similarly to the PGM and PGM PVW
work modes. The input, on which the out point was set, becomes the master angle.
This allows to set the in point when the channels are tied, and later break the
synchronization. Then, when saving the clip, the master angle is the input on which the
out point was placed.
Loading a clip
When the outputs are tied, the master angle loads on output 1, and cam A loads on out
2. If cam A is the master angle, cam B will load on output 2.
When outputs are not timed, the master angle will load only on an active channel.
To change the angle of a loaded clip:
■
Select the angle from the inputs bar on the LCD screen.
or
■
Press shift + one of the ABCD buttons
or
■
press “Take” to toggle to the next available angle.
Playlist Functionality
The Multi PGM mode allows to load a different playlist to each output channel, as
opposed to the Gang mode, which always loads the playlist to output 1. This mode also
permits to tie two playlists.
The mixing on playlist works similarly to the 2PGM mode:
• When loading a playlist to out1, out2 is reserved for mixing.
• If there is no out2, the playlist runs as a separate PGM.
• When loading a playlist to out2, it runs as a separate PGM (no mixing is available)
Summary of Contents for FastServe
