Connecting to the HTTP Server
49
Check Fibre Link
The Check Fibre Link page displays information pertaining to the attached storage arrays.
Check Fibre Link
The Fibre Link page displays the output of these three utilities:
•
array_services –i
Displays all disk devices available on the system. Sel_id is the number of the array as
seen on the MSS and in filesystem creation. Disks with Sel_ID of 0xff may be local hard
drives, or an array whose firmware rev does not match this utility.
•
array_services -l3
Use this information to verify the array can be reached and to check that the gateway is
connected to the right controller (gwy0x01 = master gwy0x02 = slave)
•
array_services -l2
Use this information to verify the array settings are correct
Summary of Contents for MediaStream ConnectPlus 1000
Page 4: ...4 ...
Page 8: ...8 ...
Page 14: ...Using This Guide 14 ...
Page 18: ...Chapter 1 Introduction 18 ...
