15
9
Windows NT displays the
Install New Modem
window stating that you have completed
modem installation successfully.
Click
FINISH
.
10
Windows NT displays the
Add RAS Device
window with the configured modem.
Click
OK
.
11
Windows NT displays the
Remote Access Setup
window.
Click
CONFIGURE
. Check to see that the modem is configured for “Dial Out Only.” Then
Click
OK.
Click
NETWORK
. Check to see that the modem is configured for “TCP/IP.”
Then Click
OK.
Then click
CONTINUE
.
12
Windows NT notifies you that Dial-Up Networking was successfully installed and will
restart the computer.
Select
RESTART
.
When Windows NT has restarted, double-click on My Computer
à
Control Panel
à
Modems icons
to display the
Modems Properties
window.
Verify that Dial-Up Networking is configured
1
Select the modem you just configured (Standard 19200 bps Modem, ComX). Click
PROPERTIES
.
2
In the “General” tab, make sure the Maximum speed is set to 19200.
Click the “Connection” tab. Make sure that the data bits, parity, and stop bits are set to 8,
none, and 1, respectively. Click the “No Call preferences” boxes.
Click
ADVANCED
.
3
The
Advanced Connection Settings
dialog box displays. Make sure the “Use flow control”
check box is cleared (no flow control) and that none of the other fields contain any values.
Click
OK
until you have reached the
Modems Properties
dialog box.
Click
CLOSE
.
You should now be at the Control Panel window.
1
Exit the Control Panel window.
Double click on the Dial-Up Networking icon. If there are already entries in the Dial-Up
networking phonebook, go to Step 2.
If there are no entries, Windows NT displays the message, “
The phonebook is empty.
Press OK to add an entry
.”
Click
OK
.
2
The
New Phonebook Entry Wizard
dialog box queries for the name of the phonebook
entry.
Enter
MEDIAswitch
into the name field.
Summary of Contents for MEDIAswitch
Page 1: ...MEDIAswitch For MediaShare Fibre Channel ...
Page 25: ...25 ...