S6L-24D, S6L-32D, and S6L-48D
14
3
“Unclaim” all CFMs, CKMs, CTMs, and the MLM by doing the following as appropriate (you do not need to unclaim the MTS):
On CFMs, CKMs, and MLM, hold down the two furthest right switches on each module until the lowest left LED lights orange.
• On CFMs, hold strip 8
Menu
and
Safe
.
• On CKMs, hold strip 7 and 8
Sel
.
• On the MLM, hold the two Flex Fader
Mute
switches.
4
Unclaim all CTMS by doing the following (refer to Figure 20):
• Using both hands, touch and hold all four corners of each CTM screen until choices appear on the display.
• Touch
Unclaim
.
After unclaiming all modules (except the MTS), you must reconfigure the surface.
To reconfigure the surface:
1
On the MTS (Master Touch Screen), tap the Gear icon in the bottom right corner and then tap
Control Surface Configuration
in the top left corner.
2
Tap the gray
Console
button in the top right corner. If necessary switch the console type to the correct console model.
3
Select the first module, tap
Assign,
then touch any fader on the corresponding module.
4
Repeat for all other modules, including CTMs (but not the MTS).
After recreating the Control Surface configuration, the final step is to pair the new S6L control surface’s new SBC with AVB.
Figure 19. Unclaiming a CFM (shown at left) and a CKM (shown at right)
“Unclaiming” a module clears its association with its previous Control Surface configuration, which is stored on the SBC.
Figure 20. Unclaiming a CTM; 4-finger hold (shown at left) and selecting Unclaim (shown at right)
Reminder: You do not need to unclaim the MTS.
S6L-24D/32D/48D
