Using the S-TEC 1500 Autopilot with the EXP5000
Entegra EXP5000 PFD
-40-
600-00157-000 Rev. 06
S-TEC 1500 Horizontal Modes
This section describes horizontal and flight director modes supported
by the EXP5000.
●
Heading Capture/Hold Mode
—Press the
Hdg Bug
button on the
PFD and rotate the right knob to set a desired heading. Press the
HDG
button on the autopilot control head to engage heading
mode. The autopilot will track the input heading. The autopilot
control head will annunciate HDG. Select a new heading at any
time while the autopilot is in heading mode and the autopilot will
track the new heading bug value.
●
Nav/Apr Mode
—Press the NAV button on the autopilot control
head to engage Nav mode.
■
If the nav source on the PFD is NAV = GPS1 or GPS2, the
autopilot will fly the active flight plan using GPS roll steering
and will annunciate NAV GPSS.
■
If the nav source on the PFD is Nav = VLOC1 or VLOC2, the
autopilot will fly the active VOR or localizer signal.
■
When a localizer is the active Nav source, the autopilot will
automatically transition to APR mode when the localizer is
captured and will annunciate NAV APR.
■
Glideslope capture is supported when the autopilot is in NAV
APR mode and ALT (altitude hold) mode.
Note:
The autopilot can be coupled only to a
Nav
source selected on the
PFD; it
cannot
be coupled to a
Bearing
source.
Note:
See the S-TEC 1500 faceplate for engaged mode annunciation.
Summary of Contents for Envision EXP5000
