Selecting the ADAHRS Source
Entegra EXP5000 PFD
-68-
600-00157-000 Rev. 06
Select the ADAHRS source from a switch mounted on the aircraft
instrument panel. To locate the ADAHRS Source Selection switch,
see the
Pilot’s Operating Handbook
for your aircraft.
If the ADAHRS that is not selected for
display fails, is in alignment, or is in fast
erect, a yellow message box describing
the condition displays in the lower right
corner of the HSI.
Note:
When both PFDs are operating normally, Avidyne recommends that
you set the ADAHRS source selection switch so that each PFD displays its
own ADAHRS data. This allows you to easily cross-check attitude,
heading, and air data.
In the case of an ADAHRS failure, set the switch to display the ADAHRS on
the remaining operating PFD.
Summary of Contents for Envision EXP5000
