Adjusting the thermostat
Tip: immerse a suitable thermometer in a clear glass bottle filled with water and place it in the middle of
the cellar. Wait at least 24 hours before checking the temperature.
lights when the
compressor is
working, during
cold cycles
°C shows the
temperature
value unit
The temperature range can be set as low as 5°C or as high as 18°C to suit your specific storage requirements.
The acquiescence temperature setting is 12°C.
How to set the temperature:
The temperature preset in factory for this model is 12 ° C. SET and the arrows are used to change settings. To
change the temperature:
•
Press SET, “SP” will be shown on the display and press SET again and the current value will be shown
Press simultaneously SET and the upper arrow
•
Press UP or DOWN arrows to change the set point value between 5 and 18°C
Press SET to accept the new value
Press SET and down arrow at the same time to exit the programming mode or wait 1 minute to automatically
exit
The thermostat in your wine cellar only controls the production of cold air. If your wine cellar is equipped with the
winter system and is intended for use in an unheated area, the heating circuit is factory preset and you do not
need to adjust it. Don’t worry if your thermometer doesn’t indicate exactly 12°C! Inertia of liquid with respect to
air is a factor of 1 to 10 and your cellar will make the necessary corrections automatically. Moreover, as the
cellar is working according cycles, if you look at the display, indicating the instantaneous temperature, during a
cold cycle it is normal that it is less than 12 ° C. Conversely, during a warm cycle, the readable temperature will
be higher than 12 ° C for a certain period of time.
5. EQUIPMENT
The ventilation system: charcoal filter
Pure air continually changed and filtered.
Your Avintage wine cellar is equipped with a continuous fresh air system, filtered by a charcoal filter. This is a 5-
cm diameter black plastic washer in the top left of the cellar at the back. It should be replaced annually and can
be bought from our partner website
or from the accessories section of the web site at
Replacing the activated charcoal filter: it must be absolutely
replaced once a year
. You can see
it from the inside as well as from the outside. It is located in the upper right corner at the bottom
of the wine cellar.
To remove it, push the charcoal filter from the inside of your wine cellar in order to remove it outside the
appliance, by the back. Finish removing it by putting your hand behind the evaporator cover. The hole visible in
the rear lower section is normal and provides negative pressure, to ensure internal air circulation.
