USA
9
USA/CA
Operation & functions
Electronic control panel
The electronic control panel (above)
ensures that the temperatures set at the
top and at the bottom of the cabinet are
maintained. This is achieved by means of
an advanced control of the refrigeration
system, the heating element, and the fan.
The set temperature will be stored in the
event of power failure.
The electronic control has the following
functions:
•
On/Off switch
•
Light switch*
•
Temperature setting
•
Temperature indication
•
Alarm for too high and too low
temperatures
•
Door alarm
*The light may either be turned on
constantly or only when the door is open.
Temperature indication
The display shows the actual temperature.
The upper digits of the display indicate the
temperature at the top of the cabinet, and
the lower digits of the display indicate the
temperature at the bottom of the cabinet.
The temperature indicator is equipped with a
built-in filter, which simulates the actual
temperature in the bottles.
Consequently, the indicator does not
react on short-term fluctuations of the
air temperature (e.g. when opening
the door for a short period of time).
Temperature settings
The cabinet temperature is set by
selecting the low temperature for the
bottom of the cabinet and the high
temperature for upper part of the unit.
The pushed air system will then
establish 6 zones of temperature
distributed evenly between the two
selected temperature settings.
Temperature setting at the
top of the cabinet
Push SET1.The temperature at the
top
of the cabinet may then be adjusted up
and down by means of the “up and
down” buttons. The temperature can be
adjusted from 46 to 72°F; however, the
top temperature cannot be set at a
lower temperature than SET2 (the
actual set point for the bottom
temperature sensor).
SE
T
1
SE
T
2
