USA
11
USA/CA
at a temperature which is a few degrees
lower than the desired
drinking temperature, as the wine will be
warmed slightly when it is poured (into the
glass.)
Single-zone setting for long-
term storage
For long-term wine storage preservation, the
top and bottom sections should both be set at
about 54°C. With identical settings for the top
(SET1) and bottom (SET 2) sections, the
controls will maintain an even temperature
throughout the cabinet. However, in case of
significant difference of temperature between
the room and the desired temperature in the
wine cabinet, there might be a slight
temperature gradient difference between the
top and bottom. The controls will maintain the
set temperature at the bottom of the cabinet,
and any deviation from the setting will
therefore occur at the top.
The difference will
vary from 1 to 7°C, depending on the ambient
temperature.
Switch from F° to C°
Press simultaneously Set1 + Down arrow for
3 sec, then press again simultaneously Set1
+ Down arrow for 7 sec; Hyi.1 appears on the
display; press 8 times the up arrow, F° .CF°
appears on the display; press Set 1, F° is
blinking, then press the down arrow to
change to C°; wait for 15 sec to exit the
setting mode.
