23
Network Connection
1.
Connecting Mode
Direct connection:
Connect the camera and computer directly via Ethernet cable.
IP connection mode:
Connect the camera to a Router or Switcher. The user can log in to access the
device using browser.
Note:
Please do not put the power cable and Ethernet cable in places where can be easily touched to
prevent video quality loss caused by unstable signal transmission.
Please make sure that your computer is in the same network segment as the camera IP address. The
device will not be accessible if the segment is not consistent. For example, AV-1280/1281’s default IP
address is 192.168.5.163, then segment 5 must be added to your computer. Specific steps are as below:
•
Open “Local Area Connection
Properties” on computer, select the “Internet
protocol version 4(TCP/IPv4)” as shown in the
picture on the left.
•
Double click or click the property of
Internet protocol version 4 (TCP/IPv4) to enter the
Internet Protocol Version 4(TCP/IPv4) Properties
window.
•
Select “Advanced” to enter the
Advanced TCP/IP Setting. Add IP and subnet mask
in the IP browser as shown in the picture below. Click “Confirm” to finish the adding IP segment.
•
User can add the corresponding network segment according to the revised IP address of the
camera.
Summary of Contents for AV-1280
Page 7: ...7 2 Ceiling mount ...
Page 12: ...12 Dimensions ...
