Jump to: Table of Content
2022/04/11
Page: 37
6.6
I
NITIAL
S
ET
-U
P
After starting the companion software, the
virtual COM port number needs to be entered.
You can find this number in the Windows
“Device Manager”.
This setting is stored for future use.
Click on ‘open COM port’ –
which will turn green
if successful. You can use the “check” button to
verify that the connection is alive.
You can use the “Check” button to verify the
connection to the Avisaro Device. It should light
up green when clicked.
The baudrate setting for “if connected through
real RS22.. “ can be ignored. This setting is used
only in special projects and not scope of this
document.
All settings are deactivated if there is no Avisaro Device attached.
6.7
U
SING THE
PC
C
OMPANION
T
OOL
Click on “Write Config” to transmit changes in the PC tool to the Avisaro device. Click on “Read Config”
to display the currently stored values (if you navigate between options, the latest settings are read of
course automatically).
Most settings become active only after reboot. This can be done in Commands
⇨
Device Control:
Reboot Device.
