7-1
7.
TROUBLE SHOOTING
The scanner will automatically perform a simple
self-test each time it is turned on. This will help
spot major system errors in the scanner itself.
When the test is initiated, the READY LED is
flashing. When the test is completed, if no error
occurs, the READY LED is steadily on.
If you have problems with the operation of your
scanner, please check the following
troubleshooting hints.
7.1
QUESTION AND ANSWER
Question:
The LED indicates that the
scanner is ready, but the
scanner does not respond to the
scan command from the host
computer.
Answer:
a) Please check if the signal
cable is firmly seated, and
invoke the scan command again.
If there is still no response,
please reset the scanner by
turning it off and then on again,
and reboot your host computer
as well.
b) Check if the driver is correctly
installed.
Summary of Contents for AV3600
