8-2
Question:
More than one sheet of paper were fed into the
scanner.
Answer:
1) Open ADF unit.
2) Remove the multi-fed sheets of paper.
3) Close the ADF unit.
4) Flatten the corners and edges; loosen the paper
before reloading it in the paper guide.
5) Check the feeding roller condition and do the
cleaning if necessary.
Question:
Paper becomes skewed in the scanner.
Answer:
1) Check the feeding roller condition; do the cleaning
if necessary.
2) Use the paper guide when feeding the paper.
Question:
When I power on the scanner, it makes noises and
will not stand ready.
Answer:
There are two possibilities:
1) You forgot to remove the shipping lock from the
scanner. Please remove the shipping lock first.
2) You did not place the scanner on a flat desktop
surface. This may cause the scanner to function
improperly.
Question:
While scanning, the scanner often makes noises or it
scans back and forth.
Answer:
Please choose lower speed from the TWAIN user
interface for low speed PC.
Summary of Contents for AV600U
