2-3
Refit the shipping retainer:
Whenever you need to transport the scanner, please follow the
instructions below:
1. Turn off the scanner.
2. Raise the document cover. You can see clearly the flatbed glass as
well as the reading engine.
3. Turn on the scanner. At this moment, the reading engine will move
a few inches forward and stay there for a few seconds. Turn off
the scanner during this pause.
4. Raise the scanner high enough to unscrew the shipping retainer
from the “use position” and fix it in the “shipping position.”
SCSI ID:
When you have several devices on a SCSI chain, you may need to adjust
the SCSI ID selector setting located on the back of the scanner(See
Figure 2-3). This setting assigns a specific "device ID" to the scanner. If
the ID number is duplicate with an existing SCSI device, please select a
new ID.
Note: The factory setting for the scanner is ID# 6. Usually, ID# 0 is
assigned to an internal hard disk drive, and ID# 7, to SCSI adapter or host.
ID# 8 and #9 are not in use actual.
Setting Terminator
The scanner is equipped with a built-in terminator switch on the rear of
the scanner. (See Figure 2-3) Turn the terminator switch on if the
scanner is to be connected to the computer as the only or the last SCSI
device. Turn the terminator switch off if the scanner is to be located
between the computer and other SCSI device.
