62
Replacing the ADF Snap-in Pad Module
After scanning approximately 30,000 pages through the ADF, the pad may be worn
out and you may experience problems with document feeding. In this case, it is
highly recommended to replace the pad module with a new one. For ordering the
pad module, please consult your nearest dealer and follow the procedure below to
replace it.
Disassembling Procedure
1.
Pull the ADF Release button and open the ADF front cover to the left.
2.
Press the top of the ADF snap-in pad as illustrated to raise the holder.
3.
Press both sides of the holder inwardly to remove it from the slot.
4.
Press both sides of the ADF snap-in pad inwardly with your fingers to pull out
the ADF snap-in pad from the slot.
Assembling Procedure
1.
Take out the ADF pad module from the box.
2.
Press both arms of the ADF snap-in pad inwardly with your two fingers. Place
it into the holes until it snaps into place.
3.
Press both sides of the ADF snap-in pad holder and insert the pins to the holes.
4.
Press down the top of the holder until it snaps into place.
ADF Release
Button
ADF Snap-in
Pad
ADF Front
Cover