Battery Installation
Low battery warning:
When the battery power becomes low, the
low battery symbol will appear on the display.
The thermometer can still be used during this
time, but the batteries should be replaced as
soon as possible. If the batteries run out
completely,
“
Lo
”
will be displayed along with
the low battery symbol. In this case, the batteries will need to
be replaced before using the thermometer again.
Replacing the Battery:
1. Gently slide the battery cover back.
2. Carefully remove the old batteries and properly discard.
3. Insert new batteries (Two 1.5V alkaline AAA Size)
according to the proper polarity.
4. Slide the battery cover back on.
NOTE: Battery-operated
1. Please properly dispose of the batteries away from small
children and heat.
2. It is recommended to remove the batteries if the unit will not
be used for an extended period of time.
3. For long durations of non-operation, please remove all
batteries from the device.
4. Batteries must be disposed of in accordance with local
environmental and institutional policies.
5. Dispose of used batteries in accordance with the applicable
legal regulations. Never dispose of batteries in the normal
household waste.
5
Switching Between Fahrenheit or Celsius
Your thermometer can display results in
either degrees Celsius (
°
C) or degrees
Fahrenheit (
°
F).
To switch between Celsius and Fahrenheit,
while the unit is on press and hold both the
Human/Object button and the Memory button
for approximately 3 seconds. This will change
the mode to either
°
C or
°
F. Once the
thermometer beeps, at which time the mode
has been changed and you may release the
buttons.
Switching between 4 Kinds of Scan Mode
1. Under power on status, you can press the Human/Object
button to switch different scan mode. There are 4 kinds of
mode which including Human, Object, Human/Night, and
Object/Night mode (in order).
2. The beep sounds will be closed when your choice in
Human/Night mode, and Object/Night mode, and the Moon
symbol will appears on the LCD in both Night mode.
NOTE:
Each press will comes with a beep sound to ensure the setting
is activated. (Except both Night modes)
6
