•
Pressing and holding the button on the remote for three seconds
while the remote start is active.
•
Parking brake is disengaged .
•
Engine over-rev protection (Tachometer mode only).
Pit Stop
This remote start can keep the engine running during short trips away
from the vehicle.
Enabling Pit Stop Mode
:
1.
Park
in a well ventilated area and
set
the parking brake.
2.
With the engine running,
set
the transmission in the park position.
3.
Press
and release the remote control button once (or the amount
of
times the system has been programmed to activate the remote
start). The parking lights turn on to confirm.
4.
Turn
off the ignition and
remove
the key, the engine continues
running.
5.
Exit
and
secure
the vehicle, the engine runs for the programmed
runtime.
Important
: This feature will not work if the brake pedal is being pressed.
Note
If your vehicle uses a Smart Key or PTS (Push-To-Start) system,
please refer to the vehicle specific instructions included with
the owner's guide of the interface module or consult your
authorized dealer.
Optional Rear Defogger
If connected, the Defogger circuit automatically activates after remote
starting the vehicle.
Note
: The optional rear defogger feature can be programmed to be
