In te rior Light Trig ger
The Diablo
2
interior light trigger wire is programmable to accept a positive
(+) or negative (-) input. The module is factory preset for negative (-) door
trigger.
1. Connect the alarm WHITE wire to the vehicle door trigger wire(s).
2. If the vehicle door trigger is positive (+) trigger, follow the "Door
Trigger Input Polarity" section in the "Programming Table for Alarm
Features" to program the module for positive (+) door trigger.
Op tional In te rior Light Il lu mi na tion Out put
The WHITE/BLACK wire provides a current limited (-) output for 30
seconds upon remote disarm. Interior light illumnination requires an
optional relay.
1. Connect the alarm WHITE/BLACK wire to relay terminal 85.
2. Connect relay terminal 86 to a fused co12 volt source.
3. Connect relay terminal 30 to the vehicle door trigger wire(s).
4. If the vehicle door trigger is positive (+) trigger, connect relay terminal
87 to a fused +12 volt source.
5. If the vehicle door trigger is negative (-) trigger, connect relay terminal
87 to ground (-).
Starter Dis able
Make sure the YELLOW relay wires are solidly connected. The starter
circuit may draw very high current. We recommend that all connections be
soldered.
1. Locate the ignition switch wireloom under the dashboard.
2. Use a voltmeter to find the one wire that will show +12 volts while the
ignition key is in the "CRANKING" cycle only. This should be the
starter solenoid wire.
3. Cut the starter solenoid wire. Test by trying to crank the starter with the
ignition key. If it does not crank, you have the correct wire.
4. Connect one YELLOW wire to the key side.
5. Connect the other YELLOW wire to the starter side.
8
Diablo
2
/AMX 68/AT-58 Installation Manual 3/31/99
