Page 2-4
7.)
If you have not already done so, open the accessory box that came
with the loom. Locate the warp beam crank and attach it to the
warp beam at the rear of the loom (as shown in Figure 6).
8.)
Sectional beam tie-up.
If you have ordered a sectional beam and
tension box, begin installation by locating the following parts (if
you haven’t ordered a sectional beam, proceed to step 15):
•
sectional beam
•
warp beam crank
•
brake cable and tie-up
•
tension box track
•
extended folding leg supports (2)
•
tension box hardware pack
•
track support legs hardware pack
•
track support legs (2)
•
tension box