Loom Assembly
Rug Loom User’s Manual
Page | 20
Square the Frame
3)
Raise the assembly into place and orient it over the appropriate
mounting holes in the Top Horizontals. The ID plate should face
forward.
Note:
Be very careful of your back; get extra help if you feel you need it.
Figure 6 - Harness Pulley Support Assembly
4)
Select two 8" hex bolt assemblies and two stud assemblies (10-
1/4" or 12-1/4" depending on your loom) from your hardware
assortment. The studs will have a nylock nut cemented at one
end.
5)
Bolt it into place. The long studs insert at the rear holes, the 8"
hex bolts in the front.
S
QUARE THE
F
RAME
In order for the loom to function well, it must be reasonably square and
level. We'll check for squareness first. You may do this with either a
carpenter's square or a 25' tape measure.
Using a Carpenter's Square:
1)
Check the loom frame at the lower rear comers. Bear against
opposing comers to adjust the frame until it comes into square.
2)
Now, go back and firmly tighten all the cross member bolts that
you previously left only snug.
Using a Tape Measure:
1)
You will use the tape to check the loom's diagonal measurements.
First measure from the inside bottom of the Left Front Vertical, to
the outside front of the right Rear Vertical. Record your
measurement.
Harness pulley
support assembly
Summary of Contents for Rug Loom
