Loom Assembly
Rug Loom User’s Manual
Page | 30
Add Harnesses to the Loom
9)
Finally, return and visually inspect each connection to be sure that
no air lines have come loose. If you find a loose end, simply push
it into the appropriately coded connector until you feel it seat.
A
DD
H
ARNESSES TO THE
L
OOM
Add Heddles to the harnesses
You'll need to load the heddles onto the harnesses before you hang them.
This is most comfortably done on a table. We provide 100 heddles per frame
with the loom. Additional heddles can be purchased at
www.avllooms.com
or
by calling us at 1-800-626-9615.
1)
Locate the Harness Cables, Heddles, Springs, and Harness
Frames.
2)
Lay a harness down and remove the heddle support clips from
one side, both upper and lower.
3)
Withdraw the Heddle Supports a few inches so the ends are free
of the harness frame.
4)
Lay a bundle of heddles opposite the free ends of the supports.
5)
The heddles are strung on cords. Tie each of the cords into the
holes at the ends of the Supports.
6)
Transfer the desired number of heddles from the bundle to the
Heddle Supports.
Summary of Contents for Rug Loom
