Loom Assembly
Rug Loom User’s Manual
Page | 38
Cloth Beam Assembly
8)
Slip the pillow blocks onto the beam axles. The grease fitting on
the right block (dobby side) should point to the rear of the loom;
that on the left, to the front.
9)
You'll need to lift the beam and insert its left end through the
frame. This will give you clearance to bring the right end into
position over the mounting holes.
10)
Position the pillow blocks over their mounting holes. You'll note
that we have scribed index lines into the frame. Align the blocks
with these lines.
Figure 23 - Cloth storage beam and pillow block
11)
Add the bolts and firmly bolt the pillow blocks in place.
C
LOTH
B
EAM
A
SSEMBLY
Again, this beam is quite heavy and you'll need to observe the usual
precautions. If you have a loom that is wider than 8’, the cloth beam will be
a steel beam that is bolted in place and does not rotate.
1)
Bring the Cloth Beam to the front of the loom. It is symmetrical,
end-to-end.
2)
For a steel beam, place the beam on the loom and bolt it into
place. Place the holes for the bolts against the loom and place the
bolts through the open end of the beam to secure.
Summary of Contents for Rug Loom
