Rug Loom User’s Manual
Warp Beams
Figure 30
6)
Add the upper bolt at each retainer and tighten.
W
ARP
B
EAMS
You will have a Sectional Warp Beam, a
of beams. All of the warp beams are
1)
Bring a Warp Beam to the rear of the loom.
2)
You'll find a Pillow Blo
3)
Remove the hardware, strip the bolts of their washers, and insert
them into the mounting holes in the blocks.
4)
Place the warp beam in either the upper or lower position
depending on where you have placed the separation beam
5)
Lift the Warp B
Verticals. Add the flat washers, lock washers, nuts,
tighten.
30 - Installing Separation Roller
e upper bolt at each retainer and tighten.
You will have a Sectional Warp Beam, a Plain Warp Beam, or a combinatio
All of the warp beams are mounted in the same way.
Bring a Warp Beam to the rear of the loom.
ou'll find a Pillow Block on each axle.
the hardware, strip the bolts of their washers, and insert
them into the mounting holes in the blocks.
Place the warp beam in either the upper or lower position
depending on where you have placed the separation beam
Lift the Warp Beam into position and push the bolts through the
Verticals. Add the flat washers, lock washers, nuts, and then
Loom Assembly
Page | 45
Warp Beam, or a combination
same way.
the hardware, strip the bolts of their washers, and insert
Place the warp beam in either the upper or lower position
depending on where you have placed the separation beam.
eam into position and push the bolts through the
and then
Summary of Contents for Rug Loom
