SkyEdgeII Modem
5
When setting the system to communicate by Ethernet, it is important to make sure the controller has a network path
to the Ethernet to Serial server so the controller can query the modem over the network. This is done by configuring
the Customer Network 1 or Customer Network 2 settings.
Note: If the modem is connected to the controller through a CIP that has been configured as a router, the Gateway
must be set to 192.168.129.1
Path
Main Window
File
Settings
AAQ Network Interface Options
Level 1
Figure 4 - Advanced Network Settings
3.
Configuration
3.1.
Core Configuration
Path
Main Window → View
Configuration
Core
Level 4
Modify the following configuration items to enable interaction of the controller to the modem. The configuration
varies depending upon the physical connection method, Ethernet or serial. If configuring to communicate over a
network set the SkyEdge II module to use the IP address and Port Number that the modem is set to.
