WDL Assembly
Workshop Dobby Loom User’s Manual
Page | 18
Beater Assembly
Hang the Harnesses
When hanging the harnesses, start at the rear most harness position and
work forward.
1)
Holding the top harness stick, lift the Harness and hook the left and
right harness cables to the eyehooks on the top harness stick. The
harness will hang from the IDU.
2)
Attach the correct harness springs to the eyehooks on the bottom
harness stick.
3)
Repeat these steps for the remaining harnesses.
B
EATER
A
SSEMBLY
The Reed Assembly (as typically delivered from the factory) is the Beater
Top, Reed, and Race, pre-assembled and secured with strapping tape. The
strapping tape should be removed before the Reed Assembly is attached to
the Beater Legs. The WDL Beater Race faces the front of the loom. You will
put together the Beater Assembly first, and then put it on the loom.
1)
Locate the Beater Legs and Reed Assembly.
Figure 29 - WDL Beater