Workshop Dobby Loom User’s Manual
WDL Assembly
Treadles
Page | 21
T
READLES
The metal Treadle Rod comes with eight stop collars. The inner-most two
stop collars are pre-located for your convenience. They are
not
symmetrically placed on the Treadle Rod.
1)
Remove the outer three stop collars on each side with the 1/8”
Allen Wrench. The two inner stop collars are locked in the correct
position for your loom.
2)
Slide the Right Treadle (shorter treadle) onto the shorter end of the
Treadle Rod with the Treadle Cable up.
3)
Slide the Left Treadle (longer treadle) onto the longer end of the
Treadle Rod with the Treadle Cable up.
Figure 30 - Left and Right Treadles
4)
Slide a stop collar onto each end of the rod and loosely position
them next to the treadles.
5)
Tighten the stop collar into place using an Allen Wrench. You now
have the Treadle Assembly.