Workshop Dobby Loom User’s Manual
Traveling with the WDL
Traveling With Your Workshop Dobby Loom
Page | 35
Remove the IDU and disassemble the frame
1)
Unclip the left and right Treadle Cables from the IDU.
2)
Unscrew the four wing nuts holding the IDU to the X-Frame.
3)
Lift the IDU out of the X-Frame and place on the ground on its
rollers. It is now ready to roll.
Figure 39 - 16" WDL with beams tied in place
4)
Loosen the two outside stop collars on the Treadle Rod. Remove the
Treadle Assembly from the X-Frame.
5)
If you need to break down the Treadle Assembly further for travel,
remove the next two sets of stop collars and remove the Treadles.
Note:
Always leave the inner stop collars on the Treadle Rod to avoid having to
adjust these at re-assembly.