Workshop Dobby Loom User’s Manual
Using the WDL
Warping Section
Page | 47
Figure 48 - Remove Raddle from Top Position
15)
Bring the raddle down to the winding-on position and secure with
the pin. Tie a knot in the thread past the raddle so it won’t slip
through.
Figure 49 - Place Raddle in Lower Position
16)
Take the extension cord from your beam. Create a larks head loop
at its end and loop it around the knotted end of your warp section.
Figure 50 - Place Extension Cord around Thread Bundle
17)
Before the last part of the threads pass through the raddle, tape the
threads on the loom-side of the raddle in their sequence using
masking tape. This will help you keep the threads in order when
you thread the harness.