Latest products and information available at www.avlite.com
16
AV-09-4WL Solar Windsock Light Kit
Assembly & Installation of the Solar Windsock Light
Tools required
• Spanner
Unpacking Instructions
Unpack all hardware and verify container contents in accordance with Figure 8 “Windsock Light Arm &
Mounting Bracket”. Please contact your Avlite Systems office if there is any hardware missing.
Initial Inspection
Inspect all hardware for damage. If there is any damage, please contact your Avlite Systems Office.
Retain original packing material for possible future use in shipping the AV-09-4WL.
Installation
Refer to Figure 8 “Windsock Light Arm & Mounting Bracket” during installation of the windsock light.
Assembling the Windsock Light Arms
Windsock Light Arms (Ref 8.2) and AV09 Lights (Ref 8.3) are assembled using bolts (Ref 8.4), spring
washers (Ref 8.5) and plain nuts (Ref 8.6).
a. Insert bolts through the light arm and AV09 from above. Fasten using spring washers and nuts. (4
places). Repeat for four complete light-arm assemblies.
Installing the Windsock Light on the Windsock Post
Light arms are attached to the main windsock post using windsock light mounting brackets (Ref 8.7).
In locating the mounting brackets consider the following:-
• The lights are fixed and are not meant to turn with the windsock.
• Lights should be mounted far enough above the windsock to avoid having the windsock foul on the
lights.
• The supplied mounting brackets (Ref 8.7) will accommodate a post size from approximately 50mm
to 175mm.
• Provision is required for the power supply cable (approx 8mm diameter) to run from the power
supply past the wind sock and up to the lights. This is most easily achieved by running the supply
cable down through the middle of the main windsock post and out through a hole near the base.
a. Locate the windsock light mounting brackets on the windsock post and clamp using screwed rods
(Ref 8.8) with washer (Ref 8.9), spring washer (Ref 8.10) and plain nut (Ref 8.11) on each end of
each rod.
b. Fit light-arm assemblies to the mounting brackets using bolts (Ref 8.12), washers (Ref 8.13) and
self locking nuts (Ref 8.14).
Note: The preferred location for windsock lights is above the windsock.
