Tracing
60
BlueFRITZ! AP-X – 6 Operating BlueFRITZ! AP-X
You will hear an acknowledgement tone to indicate that the
call has been successfully suspended. If you hear the failure
tone, this may indicate that you made a mistake, or that the
Suspend/Resume feature is disabled. It is also possible that
the Suspend ID you chose may already be in use.
To resume the connection, proceed as follows:
6.13 Tracing
The “Call Tracing” feature, technically known as “Malicious
Caller Identification” or MCID, must be enabled for your line
by your ISDN provider. Once the function has been enabled,
you can activate it using your telephone.
During a call or after the caller hangs up, dial the following
sequence:
For more information about this feature, contact your ISDN
provider.
Q
O
After the acknowledgement tone, the connection is
suspended. You can hang up the handset. The call
remains suspended at the ISDN provider’s local
switch for two minutes.
N
Pick up the handset again. You must not have a call
on hold. Otherwise, BlueFRITZ! AP-X will attempt to
suspend it.
s1
PC
s
Dial the sequence shown at left. Type in the
Suspend ID as “PC”. The suspend ID, which must
consist of either a one-digit number between 0 and
9 or a two-digit number between 00 and 99, must
be exactly the same as the one entered to suspend
the call.
Rs39r
Activating the “Call Tracing” feature.
Summary of Contents for Bluefritz! AP-X
Page 1: ......
