10
1.10.1
Setting up a wired LAN connection
All AVM devices with integrated AVM X-STREAM Engine® are hot-pluggable
. This means
that setting up a wired network connection does not require the AVM device to be restarted or
turned off and on again. Instead, a network cable (LAN cable) can be connected while the
device is running and a network connection is established immediately.
ü
Plug a LAN cable from your local router or network switch into the LAN port of the device
(28).
ü
The device automatically connects to your home network via the connected LAN cable
and is ready for use.
ü
Make sure your smartphone or tablet is connected to your local network and start the
RC X App
. After a short startup process, the
RC X App
automatically searches for
available AVM devices in your local network and lists them with their device names and IP
addresses. You can recognize an IP address by a sequence of numbers separated by
several dots. Often an IP address starts with "192.168.xxx.x".
ü
Select an available device from the list by tapping it and wait a short moment until a
connection between your smartphone or tablet and the device is established.
NOTE
: If you do not see any available devices, check if the network cable is installed correctly
and is on the same network as your smartphone or tablet. Then drag the view in the
RC X App
slightly down to search for available devices again. Please also note the
RC X App
is only compatible with AVM devices with integrated AVM X-STREAM Engine®.
You can find an overview over supported AVM devices at:
www.avm.audio/rc-x-app
.
Summary of Contents for OVATION CS 6.3
Page 1: ...Operating instructions OVATION SD 6 3 OVATION SD 8 3 ...
Page 2: ......