23
3.1.3.3
Set bass
Set the bass level between – 7 dB and + 7 dB. A global bass setting (see section above) is
indicated on the display with
GLOBAL
, otherwise
INDIVIDUAL.
3.2
Line Settings (XLR, RCA)
3.2.1
Set input attenuation
Set input attenuation
allows for an attenuation of 6 dB of the selected analog input (14-17)
which corresponds to an electrical halving of the incoming level. Activating this function might
be useful when CD players with particularly high output levels are used which otherwise cause
unwanted distortion. Take particular care when using CD players of Japanese oder American
manufacturers which are known for producing exceptionally high output levels which cannot
be compensated by a simple adjustment of the input sensitivity (see 3.1.1). In this case, a
dedicated relais is switched as soon as
set input attenuation
is activated to allow the use of
respective components with output levels.
3.3
Digital inputs (COAX, OPTO, USB)
After selecting a digital input, the currently selected filter setting and sample rate will be
shown in the upper left area of the display.
3.3.1
Set samplerate
By pressing a
VALUE
menu button once or several times, you can choose between available
sample rates for the selected digital input.
If the
BYPASS
option is selected, the display shows
NAT
and the corresponding sample rate
in the upper left corner while in general operating mode to indicate that the signal is processed
natively and without additional upsampling or downsampling.
CNV
, on the other hand, stands for
Conversion
and indicates an active up- or downsampling
to the selected and displayed sample rate.
NOTE
: For
USB
, only the two settings
NATIVE STEEP
and
NATIVE SMOOTH
are possible
(see also following section).
3.3.2
Set filter
By pressing the two menu buttons
VALUE
one or more times you can choose between
available filter settings for the selected digital input.
Summary of Contents for OVATION CS 6.3
Page 1: ...Operating instructions OVATION SD 6 3 OVATION SD 8 3 ...
Page 2: ......