To Contact Avocent Technical Support: Visit www.avocent.com
590-1011-501E
Avocent, the Avocent logo, SwitchView and Cybex are either registered trademarks or trademarks of Avocent Corporation or its affiliates in the United States and/or other countries. ©2011 Avocent Corporation.
2
Environmental
Operating Temperature:
32˚ (0˚C) to 104˚ (40˚C)
Storage Temperature:
-4˚ (-20˚C) to 122˚ (50˚C)
Operating Voltage 100-240 VAC
Power Frequency: 50/60 Hz
Typical Power Consumption:
SC380 – 10.7W (120V), 10.9W (240V)
Maximum Power Consumption:
SC380 – 25W (120V), 25W (240V)
NOTE: Power consumption figures were
determined by internal analysis. Typical
power consumption tests included a
USB keyboard, mouse and CAC reader.
Maximum power consumption tests
included a 0.5A USB load on each USB
port.
Mechanical
Approximate dimensions:
H x W x D = 1.7 in. [43.2 mm] X 17.0 in.
[431.8 mm] X 9.2 in. [233.7 mm]
Weight = 6 lbs. (2.7 kg)
Video Modes: VGA, SVGA, XGA,
SXGA, UXGA, QXGA, WVGA, WSVGA,
WXGA, WSXGA, WUXGA, WQXGA
and HDTV
Maximum Resolution: Dual link DVI up to
2560 x 1600 @ 60 Hz (monitor and
video card support for the maximum
resolution will vary and should be verified
for compatibility)
Video Adaptors
The local port connectors and cable
connectors on the SC380 switch
are DVI-I. Analog monitors require an
adaptor to connect to the VGA port
(VAD-27). Monitors with digital-only
connectors can be plugged directly
into the DVI-I connector on the SC380
switch.
Target Video Connectors
All of the target video connectors
and cable connectors on the SC380
switch are DVI-I. Target servers with
analog connectors require an adaptor
to connect to the VGA port (VAD-
28). Target servers with digital only
connectors must use an adaptor to
match up with the DVI-D port (VAD-31).
Cables
Users can choose from single-head DVI-I
cables of varying lengths and select
whether or not to use audio (speakers
and microphone).
Contact an Avocent representative for
ordering details.
Rack Mounting the Switch
NOTE: Please refer to the separate safety
sheet for important information on safely
rack mounting your switch.
1. Remove two 8-32 x 1/4 in. truss
head screws from the side of the
switch and discard.
2. Place one rack mount bracket on
the side of the switch with the
flange facing the front of the switch.
Adjust the bracket forward or back
to align the mounting holes.
3. Secure the bracket with the 8-32
x 3/8 in. stainless steel screws
included with the rack mount
brackets.
4. Repeat steps 1-3 for the opposite
side.
QUICK INSTALLATION GUIDE
SwitchView
™
SC380
8-Port DVI-I/USB Switch with Audio
