6
3. Hardware Installation
3.1 Unpack the UMG-2000 / UMG-2100 / UMG-2200
Note
You should inspect the box which the system was shipped in and
note if it was damaged in any way before the unpacking. If the
UMG-2000 / UMG-2100 / UMG-2200 itself shows damage you
should file a damage claim with the carrier to who delivered it.
Unpack the UMG-2000 / UMG-2100 / UMG-2200 as listed below.
3.2 Choosing a Setup Location
Decide on a suitable location for the UMG-2000 / UMG-2100 / UMG-2200 which
should be situated in a clean, dust-free, and well ventilated area. Avoid areas
where heat, electrical noise and electromagnetic fields are generated. Place
the UMG-2000 / UMG-2100 / UMG-2200 near a grounded power outlet and pay
attention to the following requirements.
Leave approximately 40cm (16inche) of clearance in front of the UMG-2000 /
UMG-2100 / UMG-2200 to ensure the disk carriers can be unplugged.
Leave approximately 30cm (12 inch) of clearance in the back of the UMG-2000
/ UMG-2100 / UMG-2200 to allow for sufficient airflow and ease in servicing.
