DIY Bendable LED Tape Kit
Item ref:153.736UK, 153.737UK, 153.738UK
User Manual
Introduction:
Thank you for purchasing the Lyyt Bendable DIY LED Tape Kit. LED tape is ideal for use on the underside of a
counter tops, shelves, cupboards, around window frames or in an alcove of a ceiling to name just a few
examples.
Before starting please ensure that you have read this instruction leaflet carefully. If you are
unsure about any of the installation details, please have this installed by a competent installer.
In The Box:
•
5m reel of self-adhesive LED tape
•
12Vdc UK power adaptor
•
Installation accessories
Possible Required tools: Scissors, Craft knife, Soldering iron and solder, 2 core DC wire and heat shrink tube.
Step 1: Preparation
Ensure that the surface you are attaching to is clear of dust and dirt. Clean thoroughly and leave to dry before
fitting the tape.
Unravel the tape and connect the power supply. Check that all the LEDs are functioning correctly and if there
are any faults return to your retailer without delay.
Step 2: Cutting
WARNING: Disconnect from the power supply before attempting any cutting.
Measure out each section and cut with sharp scissors at the marked 5cm intervals to achieve the perfect
length. Do not discard any excess tape as it can be easily reconnected and used again.
Step 3: Fitting:
Example 1: Simple straight run.
Clear the area you wish to install the tape and remove the backing paper, exposing the adhesive tape. Push
tape firmly onto the surface. It is recommended to work on 50cm sections at a time in order to ensure a
professional finish. When you reach the end of your installation cut at the marked cutting point.
Example 2: Requires cutting:
