MAIN MENU
22
7. MAIN MENU
Note:
This menu is available only for “SUPERVISOR”. To know more details, please refer to “6.3 User
Level Creation” at page 15.
7.1 QUICK START
7.1.1 GENERAL
QUICK START
GENERAL
CHANNEL
TITLE
ON
TIME SETUP
EVENT
STATUS
ON
SIMULATION
DATE
DISPLAY
ON
EaZy
MOUSE
SENSITIVITY
RECORD CONFIG
SETUP
EXIT
1) CHANNEL TITLE
Select to display the channel title or not (
ON
/
OFF
).
1) EVENT STATUS
Select to display the event icons or not (
ON
/
OFF
).
Note: For details about each event icon, please refer to “5.2 Local” at page 11.
2) DATE DISPLAY
Select to display the date or not (
ON
/
OFF
).
3) MOUSE SENSITIVITY
Select the mouse sensitivity by 10 levels.
4) RECORD CONFIG
Click “SETUP” to enter the setting page individually for live display, manual record, event record and timer
record.
Note:
The settings shown below depend on the setting tab you selected in this setting page.
a)
IMAGE SIZE
: Select the image size for each channel.
Note:
The options selectable for
IMAGE SIZE
depend on the camera you’re intended to connect, and
the options for selected 8CH models are up to 1280 x 720.
b)
QUALITY
: Select the video quality for each channel. The higher the value, the better the image quality.
c)
I.P.S.
: Image per Second, the higher the value, the more fluent the video.
Note:
The options selectable for “I.P.S.” depends on the camera you’re intended to connect.
d)
BITRATE (kbps)
: Select how much data to process per unit of time for each channel. The higher the
value, the better the video quality.
e)
BITRATE CONTROL
: Configure the upper bit rate limit for the selected channel if necessary.
VBR
- When the bit rate of the camera exceeds the value you set, the video fluency may be affected;
CBR
- When the bit rate of the camera exceeds the value you set, the image quality may be affected.
f)
G.O.V.
: “Group of VOPs” is used to configure the length of G.O.V. The greater of the value, the less the
bandwidth for transmission, and the poorer the image quality.
