MAIN MENU
32
7.4.2 CAMERA
ADVANCED CONFIG
CONNECTION CH1
CH2 CH3 CH4 CH5 CH6 CH7 CH8 CH9 CH10 CH11 CH12 CH13 CH14
CAMERA
BRIGHTNESS 128
DETECTION
CONTRAST 128
ALERT
SATURATION 128
NETWORK
HUE 128
DISPLAY
COV. OFF
RECORD
REC ON
NOTIFY
REC AUDIO
ON
MULTICASTING
CHANNEL TITLE
EDIT
JOYSTICK
PORT FORWARD
81
ENABLE PORT FORWARD
ON
EXIT
1) BRIGHTNESS / CONTRAST / SATURATION / HUE
Click the current value to manually adjust the brightness/contrast/saturation/hue of each channel here.
2) COV.
Select if you want to mask the selected channel under recording (
ON
/
OFF
). When this function is activated,
the wording
COV.
will be shown on the channel screen.
Note:
To hide the wording
COV.
when this function is on, go to
DISPLAY
, and set
DISPLAY COVERT
to
OFF
. For details, please refer to “7.4.6 DISPLAY” at page 39.
3) REC
Select if you want to enable recording for the selected channel (
ON
/
OFF
).
Note:
When this function is disabled, no manual, event or timer recording will be activated even if any
of these three record functions is set to
ON
.
4) REC
AUDIO
Select if you want to enable audio recording for the selected channel (
ON
/
OFF
).
Note:
This function is available only when your connected device supports audio recording.
5) CHANNEL TITLE
Click
EDIT
to input the channel title (up to six characters). The default title is the channel number.
6) PORT FORWARD / ENABLE PORT FORWARD
These two functions are used when you only want to see a single channel of this recorder remotely.
a) Set the port number for the channel in
PORT FORWARD
. The default value for CH1 is 81, and the
default value for CH2 is 82… etc. If you want to change the port number to other value, the range is from
1 ~ 65535.
b) Select
ON
in
ENABLE PORT FORWARD
.
The address of the channel will be “http://
recorder_address
:
port_number
”. Enter the address in Internet
Explorer, and see if you can access the device connected channel individually.
Note:
The user name and password are still required to access the device connected to the channel.
Make sure you know the user name and password to access the device. For details, please refer
to its user manual.
