MAIN MENU
40
7.4.7 RECORD
Note:
Please DO NOT change the date or time of your recorder after the recording function is activated.
Otherwise, the recorded data will be disordered and you will not be able to find the recorded file
to backup by time search. If users change the date or time accidentally when the recording
function is activated, it’s recommended to clear all hard disk data, and start recording again.
ADVANCED CONFIG
CONNECTION
MANUAL RECORD
OFF
CAMERA
EVENT RECORD
ON
DETECTION
TIMER RECORD
OFF
ALERT
PRE-ALARM RECORD
ON
NETWORK
OVERWRITE ON
DISPLAY
KEEP DATA LIMIT (DAYS)
OFF
RECORD
RECORD CONFIG
SETUP
NOTIFY
NVR MODE
(For selected models only)
9
MULTICASTING
JOYSTICK
EXIT
1) MANUAL RECORD
Set the manual recording function on / off.
2) EVENT RECORD
Set the event recording function on / off.
3) TIMER RECORD
Set the timer recording function on / off.
4) PRE-ALARM RECORD
Select to enable or disable the pre-alarm function (
ON
/
OFF
).
When pre-alarm and event recording functions are both activated, the recorder will record 8MB data before
an alarm / motion event is triggered.
5) OVERWRITE
Select
ON
to overwrite previous recorded data in your HDD when the HDD is full. When this function is on
and the HDD is full, the recorder will clear 8GB data from the oldest for continuous recording without notice.
6) KEEP DATA LIMITS (DAYS)
Assign how many days to save the recording data from 1 to 31 days. After the assigned day(s), the recorded
data will be removed. Select
OFF
to disable this function.
7) RECORD CONFIG
Click
SETUP
to enter the setting page individually for manual record, event record and timer record.
For details, please refer to “7.1.1 GENERAL” at page 22.
8) NVR MODE
(For selected models only)
To change the displayed channels from 36 to 64, change the mode from
9
to
16
, and the channels available
for each group will change from 9 to 16. To restore the displayed channels from 64 to 36, change the mode
from
16
to
9
.
Please note that when the mode is change, the NVR will reboot and you’ll need to reallocate the camera
display channel.
