Room Alert 32E
22
AVTECH Software, Inc.
SNMP Configuration
To begin configuring your Room Alert 32E for SNMP:
1.
In “Community Name,” you may leave the default SNMP protocol community name—
“public”—or enter a new name.
2.
You may leave “Contact (sysContact)” blank or enter a person’s name to specify who is
receiving the information.
3.
You may leave “Location (sysLocation)” blank or enter the location of your Room Alert
32E monitor.
4.
You may click
Use 2 digit SNMP
if you prefer to receive values in 2-digit rather than
4-digit format.
5.
Click
Accept Changes
at the bottom of your screen to temporarily save your settings.
You may now navigate to another screen; however, if you close the web interface before
the next step, you will lose your changes.
6.
Click
Save Settings
in the navigation bar to the left of your screen. Your Room Alert
32E will automatically reboot and commit your changes.
TIP
Room Alert 32E sends values to your 3
rd
-party SNMP
monitoring application in 4-digit format by default. 78.55° F, for
example, appears as 7855. In 2-digit format, your values are
truncated, not rounded to the nearest number. In this example,
78.55 would appear as 78.
TIP
The community name you assign here must match the one in
your 3
rd
-party SNMP monitoring application.
