Some products may not be available in your country, please contact our distributor for more details
Some products may not be available in your country, please contact our distributor for more details
9
4.INSTALLATION
Installing the core unit by
inserting it into the housing.
Please note the position of
the connector. For releasing,
please press the lever-lock to
core and pull off the unit.
Lever-
Lock
Connector
Interface
Power
LED
Metal
Clip
Once the base board is connected to power,
the power LED will light up.
Optional bracket accessories
The speed dome can be equipped with various bracket accessories for indoor and
outdoor installation. Please contact your distributor for further details.
Corner
mount
Pole
mount
Wall mount and
Power box
Ceilling
mount
Indoor wall
mount
Outdoor
Power box
Indoor ceilling
mount
Extended wall
mount
Swan-neck
mounting
bracket
Wall
mount
Indoor
embedded
mount
10
Installing the core unit to base board.
The core units and base boards are packed seperatly, in order to protect them during
transportation. After unpacking and during the installation, the core unit should be
installed as follows:
5.OPERATING THE SPEED DOME
FIRMWARE
Protocol: PELCO
Dome Address: 001
Comm 9600,N,8,1
V2.25
Initial Screen
After powering up, the camera will enter into
the self-test mode and display the status
screen (see picture left). It contains
information about the model and current
settings.
- “
"
- V2.25:
- Protocol:
- Dome address:
- Comm 9600,N,8,1:
: Model number
Current firmware version
Control protocol which currently used
Address ID of speed dome. Please refer to the section "Protocol
setup " for details
Current setting of the serial communication interface
Baud rate. Please refer to section "Baud-Rate setup" for details
No parity bit, 8 bit length, 1 stop bit. This setting cannot be changed
FIRMWARE
9600:
N, 8, 1:
Operation Screen
The operation screen can display additional
information.
Temperature: Current temperature inside the speed
dome( °C)
Cam title:
User definable camera title
Zone:
Current zone name
Pan deg.:
Pan angle, 0-359°
Tilt deg.:
Tilt angle, 0-90°
Zoom Factor: Zoom factor
Display of the information can be activated or
deactivated through the OSD menu.Pplease refer to
the system setting for detais.
The intial screen will remain on until any user action is taken. If the power-up action is
set, the initial info wil vanish immediately.
32.0
CAM TITLE
ZONE-1
285 78
18X
Pan degree
Zoom factor
Tilt degree
Zone description
Temperature
PTZ operation
For the surveillance operation, the dome can be controlled from a keyboard device ,
Multiplexer or DVR through RS485 interface. Make sure that the cable is connected
and the settings (baud rate, Address ID and protocol) of both, keyboard and the dome,
are correctly configurated. For further details on operating the PTZ, please refer to the
user’s manual of the keyboard.
