18
12
13
11
OVEN CAVITY
Do not spray or wash the thermostat bulb with
acid based products (check the product label
before use).
The manufacturer cannot be held liable for any
damage caused by incorrect cleaning.
The oven cavity should be cleaned after each use
to remove cooking residuals and or grease or sugar
which, if burnt on when the oven is used again, will
form deposits or unremovable stains as well as
unpleasant smells.
The oven MUST always be cleaned whilst it is warm
with warm soapy water. To maintain the shine of the
enamelled parts, clean them with warm soapy water,
rinse and dry them thoroughly.
NEVER use abrasive powder cleaners and pads.
ALWAYS wash the accessories used.
OVEN SEAL
The oven seal guarantees the correct functioning of
the oven. We recommend you:
• clean it, avoiding abrasive tools or products.
• check its state now and then.
If the oven door seal has become hard or is
damaged, contact our Service Centre and avoid
using the oven until it has been repaired.
OVEN SIDE-GUIDE RAILS (fig. 11)
For an effective cleaning of the oven side-guide rails,
these can be extracted unscrewing knurled nuts (G).
To fit the rails back in their place, first insert rear pins
(A) in holes (B) and then secure them with the knurled
nuts (G).
INSTRUCTIONS FOR THE USER
SELF-CLEANING PANELS
Oven walls are protected by panels coated with a
grease-proof, microporous enamel that absorbs and
eliminates splattering during baking.
If there is a lot of liquid or grease, dry immediately with
a damp sponge and heat the oven for 2 hours on the
maximum thermostat position. Wait for the oven to cool
down and then go over it again with a damp sponge. If
you are unable to remove all the substances, repeat the
above procedure.
It is, however, advisable to periodically remove the
panels and wash them with warm soapy water and dry
them with a soft cloth.
To remove them follow these instructions:
• Extract the side grids as indicated in the previous
paragraph.
• Remove both side panels (PL) (fig.12).
• Remove back panel (D) by unscrewing respective
locking screws (V) (fig. 13).
• Repeat previous operations in reverse order to
replace all elements.
IMPORTANT!!
Position both side panels (PL) by taking
the locking pin (A) out of the hole (B) (fig. 11).