23
461306964_004 01/2014
22
19
20
21
LOCATION AND AERATION
Gas cookers must always discharge the products
of combustion and the moisture through hoods
connected to flues or directly to the outside (fig. 20).
If it is impossible to use a hood, a fan installed on
the window or wall, facing the outside, is allowed and
should be switched on each time the appliance is used
(fig. 21) provided the rules and regulations in force
relating to ventilation.
POSITIONING THE COOKER
The appliances are fitted with the following parts to
enable them to be correctly positioned:
• Backguard
. The cookers which are equipped
with this accessory, leave of the factory with this
particular inserted inside the packing. In order to
install the backguard, it is necessary to loosen the
screws positioned on the back of the hob and then
to fix the backgaurd as indicated in figure 22.
• Spacers (only certain versions)
positioned behind
the rear panel to keep the appliance at the minimum
required distance from the back wall.
These must
not be removed.
•
Adjustable feet (fig. 23),
to be fitted to the
appliance, which allow the height of the cooker to be
aligned with other kitchen furniture This can be done
by means of the terminal part of the leg themselves
.
air inlet min. sect. 100 cm
2
air inlet min. sect. 100 cm
2
air inlet min. sect. 100 cm
2
INSTRUCTIONS FOR THE INSTALLER
23
22