3
(3) INSTALLATION
When the range hood is located above a gas
appliance, this distance shall be at least 65 cm
between the supporting surface for the cooking
vessels on the hob and the lowest part of the
range hood.
Make a cut-out in the joinery as follows: wide 490*265(mm) for
52CM and 665*265(mm) for model 70CM. Pic 1. Make sure you
have at least 35mm clearance from the edge of the cut-out to the
joinery.
Remove the filter and remove the screws holding the panel
Use the fixing screw supplied to attach range hood to joinery
Reinstate panel to body and fit filter
Connect ducting to hood outlet
The air must not be discharged into a flue that is used for
exhausting fumes from appliances burning gas or other fuels;
Regulations concerning the discharge of air have to be fulfilled.
The range hoods are intended to be installed over a hob having not
more than 4 hob elements.
The size of cavity
:
Summary of Contents for PPS6031
Page 1: ...PPS6031 PPS8031 Range Hood Instruction Manual ...
Page 12: ...11 ...
