C
HAPTER
5
| Gateway Configuration
WAN Settings
– 36 –
S
TATIC
IP S
ETTINGS
Selecting Static IP Address for the WAN type enables you to enter static IP
settings as assigned by the service provider.
Figure 24: Static IP Settings
The following parameters are displayed in this section on this page:
◆
IP Address
– The IP address provided by your service provider. Valid
IP addresses consist of four decimal numbers, 0 to 255, separated by
periods.
◆
Netmask
– Indicates the subnet mask, such as 255.255.255.0.
◆
Gateway
– The gateway IP address provided by your service provider.
L2TP S
ETTINGS
If your service provider supports Layer 2 Tunneling Protocol (L2TP) for your
Internet connection, configure the settings described below.
Figure 25: L2TP Settings
The following parameters are displayed in this section on this page:
◆
Enable
– Enables the L2TP settings.