•
Take appropriate precautions to disable the winch when not in use or under supervision to
prevent use by children or other unauthorized persons. Do not operate the winch when under
the influence of drugs, alcohol or medication.
•
When moving a load, slowly take up the nylon rope slack until it becomes taut. Stop and
recheck all winching connections. Be sure the hook is properly seated. If a nylon sling is used,
check the attachment to the load.
•
When using a winch to move a load, place the vehicle transmission in neutral, set the vehicle
parking brake and chock the wheels.
•
Do not machine or weld the winch. Such alterations may weaken the structural integrity of the
winch.
•
Do not power the winch longer than 120 seconds. The drum and nylon rope/synthetic rope may
get too hot.
•
Do not connect the winch to the mains as winch burnout or fatal shock may occur. Never allow
shock loads to be applied to the winch or nylon rope.
•
Use caution when pulling or lowering a load up and down a ramp or incline. Keep people, pets
and property clear of the path of the load.
INSTALLATION AND OPERATION
WARNING: Before installing this winch, disconnect the vehicle ground and positive leads
from the battery.
Always
remove jewelry and wear eye protection.
Never
lean over battery while making connections.
Always
verify area is clear of fuel lines, fuel tank, brake lines, electrical wires, etc when drilling.
Never
route electrical cables:
1. Across any sharp edges.
2. Through or near moving parts.
3. Near parts that become hot.
Always
insulate and protect all exposed wiring and electrical terminals.
Always
install terminal boots as directed.
Always
choose a mounting location that is sufficiently strong to withstand the maximum pulling
capacity of the winch.
NOTE:
The wire cable has been installed on your winch under minimal load at the factory. The
nylon rope must be re-spooled onto the drum under load so that the outer layers will not draw down
into the inner layers, damaging the nylon rope.
Installation:
1.
Install mounting kit or prepare a flat, secure mounting location for the winch.
2.
Carefully follow the instructions included with the mounting kit. The thickness of the
location must be at least 5 mm. Drill four 9 mm diameter holes in area size 124 mm x 76
mm according to image 3. Note: Different brands or models may have different mounting
possibilities.
